Viper PC 600 HF Key Fob Programming Instructions

This DEI Viper PC 600 HF system uses replacement remote: EZSDEI471, 471T, 471C

Your can pair up the system with a maximum of 4 remotes and it comes with one remote that’s already programmed to it.

To change your remote’s buttons functions and program a new transmitter just follow the steps below:

1. Turn the ignition On. Make sure you did not start the engine.

2. Within 10 seconds, press the valet switch/button by the number of times corresponding to the desired channel listed as seen on the picture below. Press the button and HOLD it.The LED will flash and do not release the button/switch yet.

3. While holding the valet switch/button, press the button on the remote that you’d like to program.

4. You can release the valet switch/button once the remote’s button is programmed.

To program from 1 channel to another by releasing the valet switch and tapping it to advance steps and then holding it. For instance: You have programmed Channel 1 and want to program Channel 2. Release the valet switch. Press it one time and release it to advance from Channel 1 to Channel 2. Now, press and HOLD the valet switch. The LED will flash two times. As before, do not release it. If you want to program the 3rd channel after programming Channel 1, release the Program switch, press it twice and release it to advance to Channel 3. Then press it again and HOLD it. LED will flash three times to confirm it’s ready to program the remote.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *