Disarm your Alarm and the red LED must be off before programming. If the alarm sounds when you open the door or start the vehicle without even using a working remote then press the valet switch/button while the ignition is ON. If did not work try it again while the ignition is OFF.
Perform these steps to program your new remote:
1. The driver’s door must be left open until the remote is programmed.
2. Press the valet button.
3. Turn the ignition to ON.
4. Within 5 seconds of step 3 press the valet button once, release it, press it again and hold it. You may hear a chirp, beep, or honk.
5. Within 5 seconds press left button on remote for 2 seconds. You may hear chirp, beep, or honk.
6. Release the valet switch/button, press again, and release it, press again, hold it. Press the right button on the remote (get chirp, beep, or honk) and release the valet switch/button, press again, release it, press again and hold it. Press both buttons on the remote and get a chirp, beep, or honk. Then release the valet switch/button.
7. Turn the ignition OFF.
If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.