Viper 800 ESP Key Fob Programming Instructions

This DEI Viper 800 ESP system uses replacement remote: EZSDEI471, 471T, 471C

ATTENTION: These types of systems can only be paired with a maximum of 4 remotes and it comes with a remote that’s already programmed to it.

But if you bought a new remote or wants to change your existing remotes button functions just follow these steps.

1. Turn ON the ignition, make sure the engine did not start.

2. Within 10 seconds press the valet switch/button the number of times corresponding to the desired channel list shown on the picture. Then you press the button one more time and HOLD it. The LED will flash and keep on holding the button/switch.

3. Press the button on the remote that you’re programming to the system.

4. When your remote’s button is programmed, that’s the time you can release the valet button/switch.

TIPS: You can advance from programming one channel to another by releasing the Program switch and tapping it to advance steps and then holding it. For instance: You have programmed Channel One and you want to program Channel Two. Release the Program switch. Press it one time and release it to advance from Channel One to Channel Two. Now, press and HOLD the Program switch. The LED will flash two times. As beffore, do not release it.

If you want to program Channel Three after programming Channel One, release the Program switch, press it twice and release it to advance to Channel Three. Then press it once more and HOLD it. LED will flash three times to confirm it is ready to receive the code from the transmitter.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *