These steps can be used to program this replacement remote to the system. In order to enter the programming mode, the system’s Valet switch/button must be plugged into the BLUE port.
1. Open driver’s door.
2. Turn the key in ignition to ON.
3. Within 5 seconds press the Valet button /switch the number of times corresponding to the desired channel, then press and hold it. LED will flash the same number of times you pressed valet button and the horn (if connected) will chirp to confirm programming mode. DO NOT release the button.
4. While holding the Valet button, press the button from the remote you wish to assign to that channel. Siren will chirp to confirm that the remote has been learned by the system.
5. Remove the key once you’re done.
If you can’t find your valet switch click here.