Please note: Make sure the Valet button/switch is plugged into the BLUE port of the receiver so you can put the system in programming mode.
1. Open the door.
2. Turn the key in the ignition to ON position.
3. Within 5 seconds press the Valet button/switch the number of times corresponding to the desired channel listed below. Then press and hold Valet button/switch (Do not release it until the remote is programmed. Your LED light will flash the same number of times as the channel selected and you may hear a chirp (if connected) to confirm the selected channel.
4. Press the button from the remote you’re programming to that channel. The unit will chirp (if connected) to confirm that the button has been programmed to the receiver.
5. Release the Valet button/switch and remove the key.
If you can’t find your valet switch click here.