Viper 671XV RemoteProgramming Instructions

This Viper 671XV system uses replacement remote: 488V, EZSDEI487

In order to switch to programming mode, the systems Valet button/switch must be plugged into the BLUE port of the receiver.

1. Open the driver’s door.
2. Turn the key in the ignition to ON position.
3. Within 5 seconds press and release the Valet button/switch the number of times corresponding to the desired channel listed below. After that, press and hold Valet button/switch. LED will flash the same number of times as the channel selected and you may hear a chirp (if connected) to confirm the selected channel. DO NOT release the button yet.

4. While holding the Valet button/switch, press the button from the remote you’re programming to that channel. The unit will chirp (if connected) to confirm that the button has been programmed to the receiver.
5. Release the Valet button/switch and remove the key.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *