System comes with one remote that is already programmed to the receiver and can save up to 4 different remote codes in it’s memory.
Steps on how to program the remote or to change the button’s functions:
1. Turn the ignition ON. Do not start the engine.
2. Within 10 seconds, press the valet button the number of times corresponding to the desired channel listed below. Then you press the button one more time and HOLD it.The LED will flash to confirm. Do not release the valet button.
3. While holding the valet button, press the button on the remote that you’d like to program.
4. Release the valet button once the code is accepted by the system.
You can program from 1 channel to another by releasing the valet switch and tapping it to advance steps and then holding it. For instance: You have programmed Channel 1 and want to program Channel 2. Release the valet button. Press it one time and release it to advance from Channel 1 to Channel 2. Now, press and HOLD the valet switch. The LED will flash two times. As before, do not release it. If you want to program the 3rd channel after programming Channel 1, release the Program switch, press it twice and release it to advance to Channel 3. Then press it again and HOLD it. LED will flash three times to confirm it’s ready to program the remote.
If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.