Valet 711T Key Fob Programming Instructions

This Valet 711T system uses replacement remote: EZSDEI490, EZSDEI491, EZSDEI471, 491T

If your alarm sounds when you open the door or start the car press valet switch for with the ignition ON. If that did not work, press the switch while the ignition is OFF. Also make sure LED light is off.

Go through all the steps once the alarm has been disarmed:

1. Open the driver door until the remote is programmed.
2. Press the valet/program button located under dash on driver’s side.
3. Turn the ignition to ON.
4. Within a few second of step 3 press the valet/program switch once, release it, press it again and hold it this time. You may hear a chirp, beep, or honk.
5. Within a few second press left button on remote for 2 seconds. You may hear chirp, beep, or honk.
6. Release the valet/program switch, press again, and release it, press again, hold it.
Press the right button on the remote (get chirp, beep, or honk) and release the
valet/program switch, press again, release it, press again and hold it. Press both
buttons on the remote and get a chirp, beep, or honk.
7. Release the switch and turn ignition to OFF.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *