NOTE: Before you use this programming instructions make sure that your system’s Valet/Program switch is plugged into it’s BLUE port as this will put the system in programming mode to accept new remote.
1. Door. Open a door.
2. Key. Turn the key to the ON position.
3. Press the Valet/Program button once the number of times corresponding to the channel listed below within 5 seconds. After that, press and hold the valet button this time. The LED should flash the same number of times as the channel selected and the siren (if was installed properly) will chirp to confirm the selected channel. DO NOT release the valet button yet.
4. Press the button on the remote that you’re assigning to that channel. If the horn siren was works, you should get a chirp and this indicates that the remote has been programmed.
5. Release the Valet button/switch then remove the key from the ignition as this will turn the programming mode off.
|This chart works on 473V, 473P, and 473T Remote|
|This chart works on 473L Remote|
If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.