Python 881XP Key Fob Programming Instructions

This Python 881XP system uses replacement remote: 479V, EZSDEI472, EZSDEI478, EZSDEI478V/P/C, EZSDEI479, EZSDEI479V/P/X

This is an instruction on how to program the remote to this system. Valet switch/button must be plugged into the BLUE port of the receiver in order to place your system on programming mode.

1. Open the driver’s door.
2. Turn the ignition to ON position using your key. Do not start the engine.
3. Within 5 seconds press the Valet button /switch the number of times corresponding to the desired channel ass seen on the picture below, then press and hold it. LED will flash the same number of times you pressed valet button and you’ll hear a chirp (if connected) to confirm the system’s programming mode. DO NOT release the button.
4. Press the button on the remote which you’d like to assign to that channel. You’ll hear another chirp to confirm that the remote has been paired.
5. Remove the key once you’re finish and release the valet button/switch.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *