Python 680XP Key Fob Programming Instructions

This Python 680XP system uses replacement remote: 479V, EZSDEI472, EZSDEI478, EZSDEI478V/P/C, EZSDEI479, EZSDEI479V/P/X

The following instruction can be used to program this replacement transmitter to the system. In order to enter the instruction, the system’s Valet/Program switch must be plugged into the BLUE port.

1. Open the driver’s door.
2. Turn the key in the ignition to ON position.
3. Within 5 seconds press Valet button /switch the number of times corresponding to the desired channel, then press and hold it. The LED will flash the same number of times you pressed it and the siren (if connected) will chirp to confirm. DO NOT release the button.
4. While holding the Valet button, press the button from the remote you wish to assign to that channel. The unit will chirp (if horn or siren connected) to confirm that the remote has been programmed.
5. Once the code is accepted you can release the Valet button and remove the key.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *