Python 4806P Key Fob Programming Instructions

This DEI Python 4806P system uses replacement remote: 7656P, EZSDEI7656A

PROGRAMMING INSTRUCTION

This system does not come with pre programmed remote. The unit can only save up to 4 remote codes in memory.

To program your new remote just follow these steps:

1. Raise the hood
2. Turn valet switch OFF
3. Turn key in the ignition to ON position.
4. Turn valet switch ON. The parking lights SHOULD turn on for 5 seconds.
5. Press channel 1 on the remote within 5 seconds of step 4. (lights will flash 5 times fast, and 2 times slow)
6. Turn ignition OFF and close the hood.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *