Please Note: The following Programming Instructions can be used to program this replacement transmitter to the system in order to enter the Programming Instructions, The system’s Valet/Program switch must be plugged into the BLUE port.
1. Open a door.
2. Turn the key to the ON position.
3. Within 5 seconds press and release the Valet/Program button the number of times corresponding to the desired channel listed below. Once you have selected the channel, press the Valet/Program button once more and hold it. The LED will flash the same number of times as the channel selected and the siren (if connected) will chirp to confirm the selected channel. Do NOT release the button.
4. Press the button on the remote that you’re assigning to that channel. If the horn siren was works, you should get a chirp and this indicates that the remote has been programmed.
5. Release the Valet button/switch then remove the key from the ignition as this will turn the programming mode off.
|This chart works on 473V, 473P, and 473T Remote|
|This chart works on 473L Remote|
If you can’t find your valet switch click here.