Python 440 HP Key Fob Programming Instructions

This Python 440 HP system uses replacement remote: 473T, 7133L, 473V, 473L, EZSDEI474

473T  Remote

473V Remote

473L Remote

7133L Remote

The following Learn Routine can be used to program this replacement transmitter to the system. In order to enter the programming mode, the system’s Valet/Program switch must be plugged into the BLUE port.

1. Open a door.
2. Turn the key to the ON position.
3. Within 5 seconds press and release the Valet/Program button the number of times corresponding to the desired channel listed below. Once you have selected the channel, press the Valet/Program button once more and hold it. The LED will flash the same number of times as the channel selected and the siren (if connected) will chirp to confirm the selected channel. Do NOT release the button.
4. While holding the Valet/Program button, press the button from the transmitter you wish to assign to that channel. The unit will chirp (if horn siren connected) to confirm that the transmitter has been taught to the receiver.
5. Once the code is learned you can release the Valet/Program button and remove the key.

This chart works on 473V, 473P, and 473T Remote

This chart works on 473L Remote

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *