FOLLOW THESE INSTRUCTION TO PROGRAM THE REMOTE TO YOUR SYSTEM:
1. Twist the key in the ignition to ON position.
2. Press the Valet button/switch 3 times (Siren Chirps).
3. Press the LOCK Button of each remote you’d like to program until you hear the chirp.
4. Twist the key in ignition to OFF position.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons which are typical for most systems. For additional channel programming beyond the 1 option button, you can use any unused button or combination of buttons not in use. In other words, to access option channel 5, 6, 7, just do follow these steps:
Start from step 3 above:
I. Press and Release the Valet/Programming button 4 additional times to get to channel
5, then Press any unused transmitter button or button combination to program.
II. From step a, Press and Release the Valet/Programming button 1 time to get to channel 6, then Press any unused transmitter button or button combination to program.
III. From step b, Press and Release the Valet/Programming button 1 time to get to channel 7, then Press any unused transmitter button or button combination to program.
Please note: Not all systems have channels above 3, check with your installation center for options your system may or may not have. This remote has the ability to operate 2 AUDIOVOX Alarms From A Single remote. To toggle on and off vehicle one or two,,, Press the Trunk/Key button + the Lock button for 5 seconds. The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode. Program this transmitter into the second vehicle’s system. Any time you are in 2nd vehicle when the transmitter is operated, the LED will flash twice for each function. When in the prime vehicle mode, the LED will flash once for each function.
If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.