Prestige AX510 Key Fob Programming Instructions

This Prestige AX510 system uses replacement remote: 07SPR, 08SPR, ELVATGB

Steps to program the remote to the system are the following:

1. Get in the car, and turn the ignition key ON.
2. Move the valet/bypass switch on – off – on – off- on then off.
3. The dash L.E.D. will flash one time, and the siren will “chirp” one time, indicating the system is ready to accept programming for channel 1, or the arm/disarm and panic functions.
4. You can assign any of the three transmitter button functions listed below to channel 1:
a) Pressing button #1 on the keychain transmitter.
b) Pressing button #2 on the keychain transmitter.
c) Pressing both buttons simultaneously on the keychain transmitter.
5 Press and hold the selected choice a, b, or c above, until the siren emits a long “chirp” to confirm that programming of channel I was successful.
6. Move the valet/bypass switch on, and then off again.
7. The dash mounted L. E. D. will flash 2 times and the siren will “chirp” one time, indicating that the system is ready to accept programming for channel 2, or the pulsed ground output for remote trunk release, remote car starter, etc.
8. You can assign anyone of the two remaining button functions listed in 4a, 4b, or 4c above to operate channel 2. You cannot use the button(s) that operate channel 1, selected in step 5, to operate channel 2.
9. Press and hold the selected choice. The siren will emits a long “chirp” to confirm that programming of channel 2 was successful.
10. Move the valet/bypass switch on, and then off again.
11. The dash mounted L.E.D. will flash 3 times and the siren will “chirp” one time, indicating that the system is ready to accept programming for channel 3.
12. Press and hold the remaining transmitter button function. The siren will emit a long “chirp” to confirm that programming of channel 3 was successful.
13. Either turn the ignition key to the off position, or move the valet switch on then off to turn programming mode off. This is indicated by a long “chirp” from the siren.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *