PERFORM STEPS TO PROGRAM THE REMOTE:
1. Turn the ignition to ON using the key.
2. Turn the valet switch/button on – off – on – off- on then off.
3. The LED will flash once, and you’ll hear a chirp from the siren once.
4. To assign any of the 3 remote’s button functions to channel one just just perform steps below:
a) Pressing button #1 on the keychain transmitter.
b) Pressing button #2 on the keychain transmitter.
c) Pressing both buttons simultaneously on the keychain transmitter.
5 Press and hold the selected choice a, b, or c above, until the siren chirps to confirm that programming the channel 1 was successful.
6. Turn the valet switch/button on, and then off again.
7. The dash mounted L. E. D. will flash twice and the siren chirps once.
8. You can assign any of the two remaining button functions listed in 4a, 4b, or 4c above to operate channel 2. You cannot use the button(s) that operate channel 1, selected in step 5, to operate channel 2.
9. Press and hold the selected choice. The siren chirps to confirm that programming of channel 2 was successful.
10. Turn the valet/bypass switch on, and then off again.
11. The dash mounted L.E.D. will flash 3 times and the siren chirps once, indicating that the system is ready to accept programming for channel 3.
12. Press and hold the remaining transmitter button function. The siren will emit a long “chirp” to confirm that programming of channel 3 was successful.
13. Twist the key in the ignition OFF position, or turn the valet switch/button on then off one additional time. Then you’ll hear a long “chirp” from the siren which means the system’s programming mode is OFF.
If you can’t find your valet switch click here.