Prestige APS255 Key Fob Programming Instructions

This Prestige APS255 system uses replacement remote: APS99BT3BCF31, APS99BT330, ELVATOA 

PROGRAMMING INSTRUCTION FOR THE REMOTE:

1. Twist the key ignition to ON position.
2. Move the valet switch on – off – on – off- on then off.
3. The dash L.E.D. will flash once, and the siren chirps one time, indicating the system is
ready to accept programming for channel 1, or the arm/disarm and panic functions.
4. You can assign any of the three remote button functions listed below to channel 1:
a) Pressing button #1 on the keychain transmitter.
b) Pressing button #2 on the keychain transmitter.
c) Pressing both buttons simultaneously on the keychain transmitter.
5 Press and hold the selected choice a, b, or c above, until the siren does long “chirp” to confirm
that programming of channel I was successful.
6. Move the valet switch on, and then off again.
7. The dash mounted L. E. D. will flash 2 times and the siren will “chirp” one time, indicating that
the system is ready to accept programming for channel 2, or the pulsed ground output for remote
trunk release, remote car starter, etc.
8. You can assign anyone of the two remaining button functions listed in 4a, 4b, or 4c above to
operate channel 2. You cannot use the button(s) that operate channel 1, selected in step 5, to
operate channel 2.
9. Press and hold the selected choice. The siren will emit a long “chirp” to confirm that
programming of channel 2 was successful.
10. Move the valet switch on, and then off again.
11. The dash mounted L.E.D. will flash 3 times and the siren will “chirp” one time, indicating that
the system is ready to accept programming for channel 3.
12. Press and hold the remaining transmitter button function. The siren will emit a long “chirp” to
confirm that programming of channel 3 was successful.
13. To exit program mode, either turn the ignition key to the off position, or move the valet switch
on then off one additional time. This is indicated by a long “chirp” from the siren.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *