Omega K-9 SS Key Fob Programming Instructions

This Omega K-9 SS system uses replacement remote: L2M449, 449-01, 499-01

Before you begin, your system must be in a disarmed state and you must know where your valet switch is located. Perform the following steps:

1) Turn the vehicle’s ignition to the “on” position
2) Within 7 seconds of step 1, press the valet switch 5 times. The alarm should respond with a long siren chirp.
3) Press the large/ lock button on your remote (for Freedom 500, C-5, and K9 Mundial2, press 2nd or 3rd channel. For MARS-22, press Lock & Unlock at the same time). The alarm should respond with a short siren chirp.
4) Repeat step 3 for each additional remote that is to operate the system (up to 4 remotes).

Note: The system will automatically exit programming mode if it detects a 15 second period of no activity.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *