Omega Excalibur AL-1000 SX Key Fob Programming Instructions

This Omega Excalibur AL-1000 SX system uses replacement remote: L2MET5A, L2MET7A, 103-01, 103-02, 103-03, 103-05, 103-08


Note: Disarm the alarm first and make sure valet switch is accessible before you program the remote to the system. Also, the system will automatically exit programming mode if it detects a 15 second period of no activity.

1) Twist the key in the ignition to ON position
2) Within 7 seconds press the valet switch 5 times. The siren should make a long chirp.

One Button Remote:
3) Press the button on your remote. The siren should make a long chirp.
4) Press the valet switch once.
5) Proceed to step 6.

Two button remote:
3) Press the large button on our remote. The siren should make a long chirp.
4) Press both buttons at the same time. The siren should make 2 long chirps.
5) Press the small button on your remote. The siren should make 3 long chirps.

Three button remote:
3) Press the large button on your remote. The alarm should respond with a short siren chirp.
4) Press the small right button on your remote. The alarm should respond with 2 short siren chirps.
5) Press the small left button on your remote. The alarm should respond with 3 short siren chirps.
6) Repeat steps 3-5 for each additional remote that you wish to operate your system (up to 4 remotes).

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *