Omega C-2 Key Fob Programming Instructions

This Omega C-2 system uses replacement remote: L2MAL41T, 110, 210

Before you begin, your system must be in a disarmed state and you must know where your valet switch is located. Perform the following steps:

1) Turn the vehicle’s ignition to the “on” position
2) Within 7 seconds of step 1, press the valet switch 5 times. The alarm should respond with a long siren chirp.
3) Press the large/ lock button on your remote (for Freedom 500, C-5, and K9 Mundial2, press 2nd or 3rd channel. For MARS-22, press Lock & Unlock at the same time). The alarm should respond with a short siren chirp.
4) Repeat step 3 for each additional remote that is to operate the system (up to 4 remotes).

Note: The system will automatically exit programming mode if it detects a 15 second period of no activity.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *