Karr 2040 Key Fob Programming Instructions

This Karr 2040 system uses replacement remote: ELVAT5H

NOTE: This instruction works on original remotes with an FCC ID: Z5000A or Z5000B.

1. Twist the key in the ignition going to ON position. Don’t start the engine.
2. Turn the valet switch/button ON and OFF 3 times. Your LED will flash and siren chirps once.
3. Press and hold the center button of the remote for three seconds. This will program button one of your remote.
4. To program a second channel, turn the valet switch/button ON and OFF. LED will flash and siren chirps twice.
5. Press and hold the 2nd button for three seconds.
6. Turn vehicle OFF.

NOTE: This instruction works on the generic replacement remote with an FCC ID: Z5000E.

1. Twist the key in the ignition going to ON position. Don’t start the engine.
2. Turn the valet switch/button ON and OFF 3 times. Your LED will flash and siren chirps once.
3. Press and hold the LOCK button for three seconds. This will program 1st and 2nd button of the remote.
4. To program a second channel just turn the valet button/switch ON and OFF. LED will flash and siren chirps twice.
5. Press and hold the TRUNK button for three seconds.
6. Turn vehicle OFF.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *