Karr 2020a Key Fob Programming Instructions

This Karr 2020a system uses replacement remote: ELVAT5H

If you’re programming the original remote with an FCC ID: Z5000A or Z5000B just follow the steps below:

1. Turn the ignition to ON.
2. Turn the valet switch/button ON – OFF 3 times. LED will flash and siren chirps once.
3. Press and hold the center button of the remote for three seconds. This will program button one of your remote.
4. If you need to program a second channel then turn the valet switch/button ON-
OFF. LED will flash and siren chirps twice.
5. Press and hold the 2nd button for three seconds.
6. Turn vehicle OFF.

If you’re programming the generic replacement remote with an FCC ID: Z5000E just follow the steps below:

1. Turn the ignition to ON.
2. Turn the valet switch/button ON – OFF 3 times. LED will flash and siren chirps once.
3. Press and hold the LOCK button for three seconds. This will program 1st and 2nd button of the remote.
4. If you need to program a second channel then turn the valet button/switch ON-
OFF. LED will flash and siren chirps twice.
5. Press and hold the TRUNK button for three seconds.
6. Turn vehicle OFF.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *