Hornet 740 Key Fob Programming Instructions

This Hornet 740 system uses replacement remote: 473T, 7133L, 473V, 473L, EZSDEI474

473T  Remote

473V Remote

473L Remote

7133L Remote

Please Note: The following Programming Instructions can be used to program this replacement transmitter to the system in order to enter the Programming Instructions, The system’s Valet/Program switch must be plugged into the BLUE port.

1. Open the driver door.
2. Insert the key in the ignition and twist it to the ON position.
3. Choose. Within 5 seconds press and release the Valet/Program button the number of times corresponding to the desired channel listed below. Once you have selected the channel, press the Valet/Program button once more and hold it. The LED will flash the same number of times as the channel selected and the siren (if connected) will chirp to confirm the selected channel. Do NOT release button.
4. Press the button on the remote that you’re assigning to that channel. If the horn siren was works, you should get a chirp and this indicates that the remote has been programmed.
5. Release the Valet button/switch then remove the key from the ignition as this will turn the programming mode off.

This chart works on 473V, 473P, and 473T Remote

This chart works on 473L Remote

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *