Crimestopper CS-2000 Key Fob Programming Instructions

This Crimestopper CS-2000  system uses replacement remote: CS-355TX, J5523518T1CS-361TX, J5523518T1, M65NVTX464

This instruction works for 335, 336, 355, 361, 340, 341, 342, 360, 365, 366

Please Note: These types of system can only keep up to 4 remotes codes in it’s memory.

1. Turn the ignition ON and OFF 3 times from OFF position then leave it to the ON position.
2. Press the valet switch 5 times then light flashes 5 times and siren chirps 6 times.
3. Press #1 (LOCK) button on the remote twice for the 360, 336, 365, 366tx’s and once for the regular TX.
4. Repeat the steps above to add another remote.
5. Turn the ignition off. Siren will chirp 3 times and lights flashe 3 times which means programming mode is OFF.

2ND METHOD

Perform all the steps below to program the remote: System can learn up to 3 different codes max.

1. Turn the Ignition ON and OFF 3 times quickly, leaving it ON the 3rd time. (ON/OFF, ON/OFF, ON) You should hear (1) short chirp.
2. Push the Program/Override button for 5 seconds until the siren chirps (3) times. Release the button.
3. Press Button #1 on new transmitter – siren will chirp to confirm programming. Repeat Step 3 within 5 sec. for up to additional transmitters.
4. Turn the ignition OFF.

Note 1: If only one transmitter is being programmed, continue pressing button #1 until dash LED flashes goes out and The system chirps to exit programming mode to prevent unauthorized codes and noise from entering the system.

NOTE 2: Programming mode is exited automatically after 5 seconds of last code transmission or once 3 new codes.

PROGRAMMING INSTRUCTIONS FOR 335, 336, 355, 361, 340, 341, 342, 360, 365, 366

1. Turn Ignition ON and OFF3 times quickly, leaving it ON the 3rd time. (ON/OFF,ON/OFF,ON) you should heard 3 chirps.
2. Press the Program/Override button 5 times and you should hear 5 light flashes and 5 siren chirps.
3 Press #1 (lock) button on the remote 2 times for the 360-336-365-366tx’s and 1 time for the regular TX.
4 Repeat the steps above for the second and 3rd Remote.
5. Turn off Ignition. Siren will chirp 3 times and lights will flash 3 times for exit confirmation.

NOTE: This system will learn a total of 4 remotes max.

METHOD-2

TRANSMITTER PROGRAMMING Note:
SYSTEM can learn up to 3 different codes max.

1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3rd time. (ON/OFF,ON/OFF,ON) You should hear (1) Short chirp.
2. Push the Program/Override Button for 5 seconds until the siren chirps (3) times. Release the button. The system is now in programming mode.
3. Press Button #1 on new transmitter-siren will chirp to confirm programming. Repeat step 3 within 5 sec. for up to 2 additional transmitters.
4. Turn off Ignition.

Note 2: If only one transmitter is being programmed, continue pressing button #1 until dash LED flashes goes out and The system chirps to exit programming mode to prevent unauthorized codes and noise from entering the system.

Note 2: Programming mode is exited automatically after 5 seconds of last code transmission or once 3 new codes.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *