Crimeguard FREEDOM 400 Key Fob Programming Instructions

This Crimeguard FREEDOM 400 system uses replacement remote: L2M432, 432-01

This type of alarm automatically enters transmitter programming mode upon power up. Before you begin, make sure that all points of entry (doors, trunk, hood) are closed. If there is a hood pin switch, have a friend hold it down or temporarily disconnect it. The system will not enter programming mode if it detects an open point of entry.

Perform the following steps:

If the system has been without power for more than 24 hours:
1) Apply power to the system.
2) Press the large/ lock button (Press small center button for Freedom 400) on your remote. The system should respond with a short siren chirp.
3) Repeat step 2 for each additional remote that is to operate the system.

If the system has had power within the last 24 hours:
1) Disconnect and re-apply power.
2) Press the large button (Press small center button for Freedom 400) on any remote that does not already operate the system (this is how the system determines that you want to program transmitters). The system should respond with a short siren chirp.
3) Repeat step 2 for each additional remote that is to operate the system.

Note: the system will automatically exit programming mode if it detects a 15 second period of no activity. If you don’t know what a valet

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *