Code AlarmPROF25 Key Fob Programming Instructions

This Code Alarm PROF25 system uses replacement remote: GOH-FRDPC2002 and GOH-TSM-23

Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from the memory in chronological order.

To program transmitters:

1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp/flash the parking lights (3) times, release the button.
4. Press Button 1 of each transmitter you wish to program. The system will respond with 1 chirp for each accepted transmitter (up to 4)
5. Turn the ignition Off to exit programming. The system will also exit the programming after 15 seconds of inactivity.

Note: This system has 1 button programming which programs all channels of the system.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *