Code Alarm CSI400 Key Fob Programming Instructions

This Code Alarm CSI400 system uses replacement remote: ELVATDB, CATX500

1. Turn the key in the ignition to ON position. (Don’t start the engine)
2. Press the valet button 3 times.
3. Press and hold LOCK button on your remote.
4. The parking lights should flash once.

For additional remotes, do “Step 3”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

5. Press the valet button once.
6. Press and hold the UNLOCK button on your remote
7. The parking lights should flash once.

For additional remotes, do “Step 6”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

8. Press the valet button once for channel 3.
9. Press and hold the TRUNK button on your remote.
10. The parking lights should flash once.

For additional remotes, do “Step 9”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

11. Press the valet button once to advance to channel 4.
12. Press and hold the STAR button on your remote.
13. Parking lights should should once.

For additional remotes, do “Step 12”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *