Code Alarm CSI300 Key Fob Programming Instructions

This Code Alarm CSI300 system uses replacement remote: ELVATDB, CATX500

1) Turn the ignition to On position.
2) Press the valet button 3 times.
3) Press and hold LOCK button on your remote.
4) Parking lights will flash once.

Go back to step 3 to program additional remotes.

5) Press the valet button once for channel 2.
6) Press and hold the UNLOCK button on the remote
7) Parking lights will flash once.

Go back to step 6 for each additional remotes.

8) Press the valet button once for channel 3.
9) Press and hold the TRUNK button on the remote.
10) Parking lights will flash once.

Go back to step 9 for additional remotes.

11) Press the valet button once to advance to channel 4.
12) Press and hold the STAR button on the remote.
13) Parking lights will flash once.

Go back to step 12 for additional remotes

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *