Code Alarm CA671 Key Fob Programming Instructions

This Code Alarm CA671 system uses replacement remote: ELVNTRCA, CA5BLCTXELVATDB, PROTX6

NOTE: This system can only program to 4 remotes.

Follow steps to program your new and existing remotes:

1. Turn the ignition switch ON.
2. Press and hold the valet button.
3. In 10 seconds the system will chirp/flash the parking lights (3) times.
4. Press the LOCK button of each remotes you’re programming and system will respond with chirping once for each accepted remote codes.
5. Turn the ignition switch OFF once you’re done. And the system will also turn programming mode off automatically after 15 seconds of inactivity.

NOTE: This system has 1 button programming which programs all channels of the system.

1) Turn the ignition to On position.
2) Press the valet button 3 times.
3) Press and hold LOCK button on your remote.
4) Parking lights will flash once.

Go back to step 3 to program additional remotes.

5) Press the valet button once for channel 2.
6) Press and hold the UNLOCK button on the remote
7) Parking lights will flash once.

Go back to step 6 for each additional remotes.

8) Press the valet button once for channel 3.
9) Press and hold the TRUNK button on the remote.
10) Parking lights will flash once.

Go back to step 9 for additional remotes.

11) Press the valet button once to advance to channel 4.
12) Press and hold the STAR button on the remote.
13) Parking lights will flash once.

Go back to step 12 for additional remotes

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *