Code Alarm CA611 Key Fob Programming Instructions

This Code Alarm CA611 system uses replacement remote: ELVATCG, CATX610ELVATDB, PROTX6

Key chain transmitters included with the system are pre-programmed, with each button pre-assigned to control a specific function of the system.Your system can only handle up to 4 remote codes. If you program another remote while the system has already saved 4 codes, then the first remote you programmed will be erased from the system.

Do these steps to program your remote:

1. Turn the key in the ignition ON position.
2. Press the valet button/switch 3 times.
3. The dash LED light will flash once, and the siren will sound once, this means your system is ready to accept programming for channel 1 which is ARM/LOCK.
4. Press and hold the LOCK button on the remote for 4 seconds and or you can just simply wait for a long chirp.
4a. Repeat step 4 for any addtional remotes you’d like to program.
5. Press and release the valet button/switch once to channel 2 this time. The dash mounted LED will flash twice and the horn/siren will sound twice, indicating that the system is ready to accept programming for channel 2 which is DISARM/UNLOCK.
6. Press and hold the UNLOCK button on the remote for 4 seconds or wait for the long chirp.
6a. Repeat step 6 for any additional remotes you’d like to program.
7. Press and release the valet button/switch once to advance to the 3rd channel. The dash mounted LED will flash 3 times and the horn/siren will sound 3 times, indicating that the system is ready to accept programming for channel 3 which is TRUNK RELEASE/REMOTE START.
8. Press and hold the TRUNK KEY/KEY BUTTON on the remote for 4 seconds or just simply wait for a long flash from the parking lights.
8a. Repeat step 8 for any additional remotes.
9. Press and release the valet button/switch once to advance to channel 4. The dash mounted LED will flash 4 times and the horn/siren will sound 4 times, indicating that the system is ready to accept programming for channel 4 which is an optional device.
10. Press and hold the OPTION button on the remote for 4 seconds or until a long flash from the parking lights.
10a. Repeat step 10 for any additional remotes.

1. Turn the key in the ignition to ON position. (Don’t start the engine)
2. Press the valet button 3 times.
3. Press and hold LOCK button on your remote.
4. The parking lights should flash once.

For additional remotes, do “Step 3”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

5. Press the valet button once.
6. Press and hold the UNLOCK button on your remote
7. The parking lights should flash once.

For additional remotes, do “Step 6”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

8. Press the valet button once for channel 3.
9. Press and hold the TRUNK button on your remote.
10. The parking lights should flash once.

For additional remotes, do “Step 9”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

11. Press the valet button once to advance to channel 4.
12. Press and hold the STAR button on your remote.
13. Parking lights should should once.

For additional remotes, do “Step 12”. Lights will flash every time you press the LOCK button for each remotes you’re programming.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *