Code Alarm CA520A Key Fob Programming Instructions

This Code Alarm CA520A system uses replacement remote: ELVATCG, ELVATEC

1. Turn your key to ON position.

2. Press and release the valet switch 3 times. LED mounted from the dash will flash once same as the parking lights, which means the system is ready to accept programming for the LOCK button on the remote.

3. Press and hold the LOCK button on the remote for 4 seconds or just wait for the parking lights to flash. Go back to step 3 for each additional remote you wish to program.

4. Turn your key to OFF position and test the remote.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *