1. Start the engine or leave the key turned to ON position in the ignition.
2. Enter your PIN # using the Plainview 2 valet switch.
Note: The Factory default PIN is “2” and can be entered by pressing the * button twice then the â€˜blank’ button once on the Plainview 2 valet switch.
3. Press and HOLD the * button until you hear one chirp and the Status LED turns on, then RELEASE the * button.
4. Press the â€˜blankâ€™ button once. Pause until you hear the chirp.
5. Press the * button once. The siren will chirp once as you push the button.
6. Press the lock/unlock button on your new transmitter. The siren will chirp once.
7. Press the lock/unlock button a second time. The siren will chirp twice which mean the remote has been successfully programmed.
8. Turn the ignition off and remove the key. The alarm will chirp three times.
9. Test the remote by pressing the lock/unlock button.
If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.