The following Learn Routine can be used to program this replacement transmitter to the system in order to enter the Learn Routine, The system’s Valet/Program switch must be plugged into the BLUE port.
1. Open your car’s door.
2. Put the key in the ignition and turn it to the ON position.
3. Press and release the Valet/Program button within 5 seconds the number of times corresponding to the channel listed below. Once you have selected the channel, press and hold the valet button this time. The LED should flash the same number of times as the channel selected and the siren (if was installed properly) will chirp to confirm the selected channel. DO NOT release the valet button yet.
4. Press the button from the remote you’re assigning to that channel. If the horn siren was works, then you should get a chirp which means the remote has been programmed.
5. Once the code is learned you can release the Valet/Program button and remove the key.
|This chart is for 473V, 473P, and 473T Remote|
|This chart is for 473L Remote|
If you can’t find your valet switch click here.