Autopage RS727LCD Key Fob Programming Instructions

This Autopage RS727LCD system uses replacement remote: XT-33, H50T21

These types of systems can only save a maximum of 4 remotes in it’s memory. If the memory exceeded, the security system will start deleting saved remotes from it’s memory in chronological order.

1. Twist the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds push the valet switch/button 2 times and hold it on your 2nd push until a long chirp is heard then release it. You are now in the programming mode.
3. Press and hold any button on the remote until the siren responds with a chirp, which means the remote has been programmed.
4. If you have an additional remote, just repeat step 3 for each remotes.

Turn ignition to OFF postion, or leave it for 15 seconds. 3 long chirps & 3 parking ligh flashes will confirm exit.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *