Autopage RS-662 Key Fob Programming Instructions

This Autopage RS-662 system uses replacement remote: XT-33, H50T21

NOTE: This system can only program 4 remotes. If the memory has exceeded, the security system will start deleting remote codes from it’s memory in chronological order.

1. Twist the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds push the valet switch/button 2 times and hold it on your 2nd push until a long chirp is heard then release it. You are now in the programming mode.
3. Press and hold any button on the remote until the siren responds with a chirp, which means the remote has been programmed.
4. If you have an additional remote, just repeat step 3 for each remotes.

Note: Twist the ignition to OFF postion, or leave it for 15 seconds. Three long chirps & 3 parking light flashes will confirm exit from programming mode.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *