Autopage RS-660 Key Fob Programming Instructions

This Autopage RS-660 system uses replacement remote: XT-33, H50T21

In the event, you should need to add or replace a Remote Control Transmitter, it is important that you follow the instructions below.

Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from memory in chronological order.

1. Turn the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds push the valet switch 2 times and holding in on 2nd push until a long chirp is heard then release the valet switch. You are now in the Transmitter programming mode.
3. Press and hold any button of the transmitter until the siren responds with a confirming chirp, indicating the signal has ben stored into memory.
4. If you have additional transmitters (up to 4) that need to be programmed, repeat step 3 for each transmitter.

Exit: Twist the ignition to OFF position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit from programming mode.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *