Autopage RS-650Plus Key Fob Programming Instructions

This Autopage RS-650Plus system uses replacement remote: XT-33, H50T21

ATTENTION: This system can only program 4 remotes. The security system will start deleting remote codes from it’s memory in chronological order if the memory has exceeded.

1. Twist the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds press the valet switch/button twice and hold it on your 2nd press until a long chirp is heard. You are now in the programming mode.
3. Press and hold any button on your remote until the siren chirps.
4. If you have an additional remote, just repeat step 3 for each remotes.

Twist the key in the ignition to OFF position. Three long chirps and 3 parking light flashes indicates the programming mode is off.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *