Autopage RS-622 Key Fob Programming Instructions

This Autopage RS-622 system uses replacement remote: XT-33, H50T21

These types of systems can only save a maximum of 4 remotes in it’s memory. If the memory exceeded, the security system will start deleting saved remotes from it’s memory in chronological order.

1. Twist the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds push the valet switch/button 2 times and hold it on your 2nd push until a long chirp is heard then release it. You are now in the programming mode.
3. Press and hold any button on the remote until the siren responds with a chirp, which means the remote has been programmed.
4. If you have an additional remote, just repeat step 3 for each remotes.

Turn ignition to OFF postion, or leave it for 15 seconds. 3 long chirps & 3 parking ligh flashes will confirm exit.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *