Autopage RS-600 Key Fob Programming Instructions

This Autopage RS-600 system uses replacement remote: XT-20LCD, H50TR11

This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from memory in chronological order. In the event, that you’d need to add or replace a Remote just follow the instructions below.

1. Twist the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds press the valet switch/button twice and hold it on your 2nd press until a long chirp is heard. You are now in the programming mode.
3. Press and hold any button on your remote until the siren chirps.
4. If you have an additional remote, just repeat step 3 for each remotes.

To exit programming mode just twist the ignition to OFF position then you’ll hear 3 long chirps and 3 parking light flashes.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

1 thought on “Autopage RS-600 Key Fob Programming Instructions”

Leave a Reply

Your email address will not be published. Required fields are marked *