In the event, you should need to add or replace a Remote Control Transmitter, it is important that you follow the instructions below.
Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from memory in chronological order.
1. Twist the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds push the valet switch/button 2 times and hold it on your 2nd push until a long chirp is heard then release it. You are now in the programming mode.
3. Press and hold any button on the remote until the siren responds with a chirp, which means the remote has been programmed.
4. If you have an additional remote, just repeat step 3 for each remotes.
Twist the ignition to OFF postion, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit from programming mode.
If you can’t find your valet switch click here.