Autopage RF-410 Key Fob Programming Instructions

This Autopage RF-410 system uses replacement remote: XT-33, H50T21

This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from memory in chronological order. In the event, that you’d need to add or replace a Remote just follow the instructions below.

1. Twist the key in ignition OFF/ON 3 times and stay in ON position.
2. Within 15 seconds push the valet switch/button 2 times and hold it on your 2nd push until a long chirp is heard then release it. You are now in the programming mode.
3. Press and hold any button on the remote until the siren responds with a chirp, which means the remote has been programmed.
4. If you have an additional remote, just repeat step 3 for each remotes.

Twist the key in the ignition to OFF postion. Three long chirps and 3 parking light flashes indicates the programming mode is off.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *