Autopage RF-1055KE Key Fob Programming Instructions

This Autopage RF-1055KE system uses replacement remote: XT-33, H50T21

If the memory exceeded, the security system will start deleting saved remotes from it’s memory in chronological order. These types of systems can only save a maximum of 4 remotes in it’s memory.

1. Turn the key in the ignition OFF/ON 3 times and stay in ON position.
2. Within 15 seconds push the valet switch 2 times and holding in on 2nd push until a long chirp is heard then release the valet switch. This means you’re in programming mode.
3. Press and hold any button on the transmitter until the siren responds with a confirming chirp, indicating the signal has been stored into memory.
4. If you have additional transmitters (a maximum of 4) that need to be programmed, repeat step 3 for each transmitter.

NOTE: Turn ignition to OFF position, or leave it for 15 seconds 3 long chirps & 3 parking light flashes will confirm exit.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *