Automate AM7 Key Fob Programming Instructions

This DEI Automate AM7 system uses replacement remote: 473A, EZSDEI474V

You’d know what type of system (Start/Ignition) installed in your car by checking the owner’s wallet card.

Perform these steps for Starter Kill System.

1. Key Start. Turn the key to start position. If the vehicle doesn’t start then jump to step 3. If the vehicle starts then the starter kill system is not armed proceed to step 2.
2. Key Off. Turn key off and wait for 40 seconds. Turn the key to the start position and the vehicle should not start.
3. Cycle. Turn the key OFF and then cyclce the key from off to start position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Learn. Press button 1 on the transmitter within 5 seconds (the starter cranks). Repeat steps above to learn up to a total of 4 transmitter.
5. Test. Turn the key OFF and wait 30 seconds. Press transmitter button 1, turn the key to start, the vehicle should not start. Test transmitter button 2. Turn the key to ignition and press transmitter button 2. Turn the key to start. the vehicle should crank and start.

Perform these steps for Ignition Kill System.

1. Key. Turn the key to the ignition position. If the power is present, then the ignition kill system is not armed. If no power is present proceed to step 3.
2. Key Off. Turn key off and wait for 40 seconds. Turn the key to the start position and the vehicle should not start.
3. Cycle. Turn the key OFF and then cyclce the key from off to start position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Learn. Press button 1 on the transmitter within 5 seconds (the starter cranks). Repeat steps above to learn up to a total of 4 transmitter.
5. Test. Turn the key OFF and wait 30 seconds. Press transmitter button 1, turn the key to start, the vehicle should not start. Test transmitter button 2. Turn the key to ignition and press transmitter button 2. Turn the key to start. the vehicle should crank and start.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *