Automate AM6.2 Key Fob Programming Instructions

This DEI Automate AM6.2 system uses replacement remote: 7111L, 7111A, 7111R

The system can store up to 4 different remote control codes in memory and comes with 2 remotes that are already programmed to it. Use the following instruction to program your new and existing remote.

Valet switch/button is usually plugged into the receiver’s blue port, and used for programming.

1. Turn the key the ignition to ON. Don’t start the engine.

2. Within 10 seconds, press the valet switch/button the number of times corresponding to the desired channel listed shown on the picture below. Once you have selected the channel, press the valet switch/button and HOLD it. LED will flash to confirm the selected channel. Do not release the valet switch/button yet.

3. Press the key button program the remote or to reset one of the features in the remote programming grid. The horn honks to confirm that the code has been successfully accepted.

4. You can release the valet switch button once you’re done.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *