Automate AM1 Key Fob Programming Instructions

This DEI Automate AM1 system uses replacement remote: 473A, EZSDEI474V

The following steps can be used to program this replacement remote to the system. Refer to the owner’s wallet card to find which system (ignition or start) was installed.
Starter kill system program instruction.
1. Turn the key to start position. If the vehicle doesn’t start jump to step 3. If the vehicle starts then the starter kill system is not armed proceed to step 2.
2. Turn the key OFF and wait for 40 seconds. Turn the key to the start position and the vehicle should not start.
3. Turn the key OFF and then cycle the key from off to start position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Press button 1 on the transmitter within 5 seconds (the starter cranks). Repeat steps above to learn up to a total of 4 transmitter.
5. Turn the key OFF and wait 30 seconds. Press transmitter button 1, turn the key to start, the vehicle should not start. Test transmitter button 2. Turn the key to ignition and press transmitter button 2. Turn the key to start. the vehicle should crank and start.
Ignition kill system program instruction.
1. Turn the key to the ignition position. If the power is present, then the ignition kill system is not armed. If no power is present proceed to step 3.
2. Turn key off and wait for 40 seconds. Turn the key to the ignition position. Power should be present.
3. Turn the key OFF and then cycle the key from off to ignition position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Press button 1 on the remote within 5 seconds (the ignition has power). Repeat steps above to program up to a total of 4 remotes.
5. Turn the key OFF and wait 30 seconds. Press remote’s button 1, turn the key to ignition position. The ignition should not have power. Test transmitter button 2. Turn the key to ignition and press the remote’s button 2. Turn the key to start. the vehicle should crank and start.
If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *