Automate 6414A Key Fob Programming Instructions

This Automate 6414A system uses replacement remote: 471A, EZSDEI471A

You can check the owner’s wallet card to find out which system (ignition or start) was installed in your vehicle.

STARTER:

1. Turn the key to the start position. if the vehicle does not start then proceed to step 3. If the vehicle starts then the starter kill system is not armed. proceed to step 2.
2. Turn key off and wait for 40 seconds. Turn the key to the start position and the vehicle should not start.
3. Turn the key OFF and then cycle the key from off to start position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Press “Automate” on the remote within 5 seconds (the starter cranks). Start from the top to program up to 4 remotes.
5. Turn the key OFF and wait 40 seconds. Turn the key to start, the vehicle should not start. Shake the remote to transmit disarm signal, turn the key to start, the vehicle should crank and start. If this procedure did not work, press the “Automate” button and try again.

IGNITION:

1. Turn the key to the ignition position. if the power is present, then the ignition kill system is not armed. If no power is present proceed to step 3.
2. Turn key off and wait for 40 seconds. Turn the key to the ignition position again. Power should be present.
3. Turn the key OFF and then cycle the key from off to ignition position 3-times within 5 seconds and then hold in the ignition position on the 4th turn.
4. Press “Automate” on the remote within 5 seconds (the ignition has power). Start from the top to program up to 4 remotes.
5. Turn the key OFF and wait 40 seconds. Turn the key to start, the vehicle should not start. Shake the remote to transmit disarm signal, turn the key to start, the vehicle should crank and start. If this procedure did not work, press the “Automate” button and try again.

If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.

Leave a Reply

Your email address will not be published. Required fields are marked *