The system comes with one transmitter that has been taught to the receiver. The receiver can store up to 4 different transmitter codes in memory. use the following learn routine to add transmitter to the system or to change button assignment if desired.
The program switch, plugged into the blue port, is used for programming. there is a basic sequence of steps to remember whenever programming this unit: Key, Choose, Transmit and Release.
1. Key. Turn the ignition to the On position.
2. Choose. Within 10 seconds, press and release the program switch the number of times corresponding to the desired channel listed below. Once you have selected the channel, press the switch once more and HOLD it.The LED will flash to confirm the selected channel. Do not release the Program switch.
3. Transmit. While HOLDING the program switch, press the button on the transmitter that you would like to control the selected receiver channel.
4. Release. Once the code is learned, the program switch can be released.
You can advance from programming one channel to another by releasing the Program switch and tapping it to advance steps and then holding it. For instance: You have programmed Channel One and you want to program Channel Two. Release the Program switch. Press it one time and release it to advance from Channel One to Channel Two. Now, press and HOLD the Program switch. The LED will flash two times. As beffore, do not release it.
If you want to program Channel Three after programming Channel One, release the Program switch, press it twice and release it to advance to Channel Three. Then press it once more and HOLD it. LED will flash three times to confirm it is ready to receive the code from the transmitter.
If your vehicle’s system was installed without the valet switch you can order one and install it to make it easier to do the programming.