350Plus Key Fob Programming Instructions

This DEI 350Plus system uses replacement remote: 7145V, EZSDEI7141, 3105V, 4105V, 3305V

Disarm your alarm first before you proceed programming. The red LED must be off. If there is no working remote and the alarm sounds when you open the door or start the vehicle then do the following: Press valet switch for one second and release with the ignition ON. If that doesn’t work then do it with ignition OFF.

Adding a new remote for DEI 350Plus System.

1. Open driver door until the remote is programmed.
2. Turn the ignition to ON.
3. Within 5 seconds of step 2 press the valet/program switch 7 times, and hold it on the eighth. You may hear a chirp, beep, or honk and the LED light on dash will flash. Do not release valet/program switch.
4. Within 5 seconds press the LOCK button on the remote transmitter. You may hear chirp, beep, or honk.
5. Release the valet/programming switch.
6. Turn ignition to OFF.

If you can’t find your valet switch click here.

Leave a Reply

Your email address will not be published. Required fields are marked *