This keyless remote programming instruction works on this remote with part # 28268-ZT03A, 28268-EA000, 28268-EA00A and FCC id CWTWB1U415, CWTWB1U733, CWTWB1U821
ATTENTION: By placing your receiver in programming mode it’s memory will be automatically erased.So, make sure to reprogram your existing remote too if you are to use them.
1. Close and lock all doors with the driverÃ¢â‚¬â„¢s side lock/unlockswitch.
2. Put the key in the ignition and remove it from the ignition key cylinder at least six
times within 10 seconds. Your Hazard Lamps will flash if you do this
step successfully. System will not enter programming mode if you do this step too fast.
3. Put key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push ANY button on the remote ONCE. Your Hazard Lamps
should flash. Indicating the remote and system is paired.
5. If there are any remaining transmitters (including the old ones), unlock then lock
all doors using the driverÃ¢â‚¬â„¢s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).
6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driverÃ¢â‚¬â„¢s side power lock/unlock switch and open the driver side door.